60104
Facet Posi-Flow Low-Pressure Fuel Pump.
Using Facet's proven "Posi-Flow" technology, the low pressure version of the Posi Flow pumps is for engines of up to circa 150 HP.
Pump specification:
- Flow rate 25 Gallons/hour / 94 liters per hour
- Pressure: 1.5 - 4 PSI / 0.1 - 0.28 Bar
- Dry prime height 1 Ft - 0.3 Mtrs
- Pipe union thread size: 1/8" NPTF tapered thread
- 12 Volt negative earth
- Suitable for nearly all fuels, including modern ones, but NOT suited for Methanol
Please note that failure to operate the pump without a suitable filter voids the warranty!
Suitable screw-on filters can be found HERE.
Only available in 12 Volt, with negative earth, the maximum width is around 88mm not accounting for any fuel unions, while the height is some 60mm.
The width of the base is around 78mm with a heart-to-heart distance for the bolt holes of 65mm.
Depending on your vehicle's carburetors and the Facet pump of your choice, it might be required to use a pressure regulator.
Please check the pump specifications against the requirements of your vehicle to be sure.
Also please note: this concerns ONLY the pump body... no further connectors or mounting material!
Couplings Specifications:
Connection to pump body: 1/8" NPTF tapered thread.
Please use our superior quality PTFE tape each time that you (re-)assemble screwed connections in the fuel tract in order to properly seal the connection.
As an alternative, you can use our Loctite 243 Thread Locker which will offer the added properties of protecting your connections from undoing themselves.
We strongly advise you to secure your fuel lines using our Stainless Steel Hose Clips.
When using an electrical fuel pump, we also advise you to equip your vehicle with an Inertia Fuel Cut-Off Switch as a safety precaution.
Facet Pump Number: 60104
* Facet Posi-Flow pumps are assembled in the USA *
A hi-res version of this Facet Posi-Flow schematic can be downloaded HERE.