79507
Needle valve assembly for various Weber carburetors.

Please verify carefully if this is the correct needle valve for your carburetor as Weber has produced a myriad of different versions over the years!

This is a so-called "Needle Valve Assembly" as it is more than just the "needle".

The assembly, or set, is supplied as seen on the photograph here and consists of a base and a needle.

The base, that is screwed into the top cover, is drilled to a specific size or calibration and it is this that determines the flow of fuel.

The needle, with its typical pointed tip, slides into the base and is equipped with a spring-loaded ball and a bracket which allows it to be hooked onto the float.

The base is engraved with the calibration size.

Available in the following sizes:

• 150
• 175
• 200
• 225
• 250

This product is priced, and sold, as a single unit.

Weber Part Number: 79507

To order the correct size needle valve for your application, please check your existing needle valve for its markings.
You then need to select the correct size / calibration by selecting it through the drop-down menu marked "Size / Calibration *" just above the "Add to cart" button on this page.
The system will not allow you to order this needle valve without selecting a size.